Safety Instructions - oneConcept X4 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
16

SAFETY INSTRUCTIONS

Power supply
Connect the +12 V power supply lead only after all the other leads have
been connected
Be sure to connect the ground lead of the unit securely to a metal point of
the car. A loose connection may cause a malfunction of the amplifier.
Be sure to connect the remote control lead of the car audio to the remote
terminal.
When using a car audio without a remote output on the amplifier, connect
the remote input terminal (REMOTE) to the accessory power supply.
Use the power supply lead with a fuse attached (40 A).
Place the fuse in the power supply lead as close as possible to the car
battery.
Make sure that the leads to be connected to the +12 V and GND terminals
of this unit are larger than 10-Gauge (AWG-10) or have a sectional area of
more than 5 mm².
General safety notes
This unit is designed for negative ground 12 V DC operation only.
Use speakers with suitable impedance. (2 to 16 ohm, stereo).
Do not connect any active speakers (with built-in amplifier) to the speaker
terminals of the unit.
Avoid installing the unit where
it would be subject to high temperatures such as from direct sunlight
or hot air from the heater.
it would be exposed to rain or moisture.
it would be subject to dust or dirt.
lf your car is parked in direct sunlight and there is a considerable rise in
temperature inside the car, allow the unit to cool down before use.
When installing the unit horizontally, be sure not to cover the fins with the
floor carpet etc.
lf this unit is placed too close to the car radio, interference may occur. ln
this case, relocate the amplifier away from the car radio .
lf no power is being supplied to the master unit, check the connections.
This power amplifier employs a protection circuit to protect the
transistors and speakers if the amplifier malfunctions. Do not attempt
to test the protection circuit by covering the heat dink or connecting
improper loads.
Do not use the unit on a weak battery as its optimum performance
depends on a good power supply.
For safety reasons, keep you car audio volume moderate so that you can
still hear sounds outside your car.

Publicidad

Tabla de contenido
loading

Productos relacionados para oneConcept X4

Este manual también es adecuado para:

A41000034510000346

Tabla de contenido