Manhattan 153522 Manual Del Usuario página 2

7 1
Setup
1 Connect a keyboard and a
mouse to the USB ports.
2 Connect display(s) to the HDMI output(s).
3 (Optional) Connect a mic, a speaker
or both to the KVM outputs.
4 Use the included combo cables to connect the
appropriate ports on your computers (HDMI,
USB-A, mic and speaker cables) to the KVM
inputs (HDMI, USB-B and combo audio cable).
5 (Optional) Plug in a USB device to the USB
hub port on the front of the KVM switch.
NOTE: If it is necessary to turn off the power to the switch, you
must do the following before turning it back on:
1 Unplug the data cables from all the
computers connected to the switch.
2 Unplug the power adapter cable from
the switch if one is connected.
3 Wait 10 seconds. If a power adapter
Hotkeys
Hotkeys let you use the keyboard to perform switch functions such as selecting a different computer,
turning the buzzer on or off, and more. This switch provides four hotkey combination modes you can
choose from: 【 CTL】+【SHIFT】,【SCROLL】 + 【SCROLL】, 【 NUM】 + 【NUM】 and【CAPS】 + 【CAPS】 .
The following table shows hotkey combinations that use the primary hotkey inputs【CTL】 + 【SHIFT】
and how to switch to the other modes. If you switch to a new hotkey combination mode, the key
combinations to complete a function are the same after you press the new the primary inputs (for
example, if you change the hotkey combination mode to【NUM】 + 【NUM】, 【NUM】 + 【NUM】 + 【B】
turns the buzzer on or off). The default hotkey combination to switch to the next online computer
port in any mode is (left) 【 CTL】 + 【CTL】 . Be sure to press the hotkey combinations quickly; each key
times out after five seconds. For the complete list of commands, go to manhattanproducts.com.
2
English
2
3
User Manual
4
6 Turn on your connected
computers and equipment.
7 This KVM switch is USB powered. If more
power is needed, connect an appropriate
power supply (9.0 V / 0.3 A) to the power input.
8 Switch between your computers via the
buttons on the front of the KVM switch
(a buzzer sounds to indicate success) or
use the hotkeys described below.
• LEDS: Red = computer is online;
Green = computer is selected
was connected, plug the power
adapter cable back into the switch.
4 Connect the computer data cables
and turn on the computers.
5 8