Homewerks 10-B1-TSACH-B Guia De Inicio Rapido

TUB AND SHOWER
TRIM KITS
MODELS
10-B1-TSACH-B – Chrome tub and shower
10-B1-SACH-B – Chrome shower only
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Shower head
B Shower arm
C Shower arm flange
D Acrylic handle assembly
E Tub spout with diverter
F Escutcheon
NOTE: Contents dependent upon model number.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package contents list and hardware contents. If any
part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Groove
Joint Pliers, Pipe Wrench, Phillips Head Screwdriver, Pipe Tape or Pipe
Thread Compound, 12 mm Hex Wrench and Supply Lines
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • www.homewerksww.com
QUANTITY
1
1
1
1
1
1
A
CAUTION
• If you solder the joints during installation of the faucet, the seats,
• Cover the sink drain to avoid losing parts.
Installations may vary depending on how the previous tub and shower
faucet was installed. Supplies necessary for the installation of the faucet
are not all included; however, they are available wherever plumbing
supplies are sold.
Prior to beginning installation, turn off the hot or cold water lines, then
turn on the old tub and shower faucet to release built-up pressure. When
installing the new faucet, hand tighten the connector nuts. DO NOT
OVERTIGHTEN. Connections that are too tight will reduce the integrity
of the system.
C
B
F
D
cartridges, and washers must be removed before using a flame
or the warranty will be voided on these parts.
E
02-15-2017