Glacier bay 67094-6001 Guía De Uso Y Mantenimiento página 6

Installation (continued)
3
Preparing the pop-up assembly
□
Remove the stopper (E) and ange (F).
□
Screw the nut (H) all the way down, and push
the gasket (G) down.
G
H
5
Installing the horizontal rod,
stopper, and strap
□
Remove the pivot nut (J).
□
Install the horizontal rod (K) and stopper (E), as
shown (1).
□
Hand tighten the pivot nut (J).
□
Attach the horizontal rod (K) to the strap (N)
using the clip (L).
E
F
4
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the ange (F).
□
Insert the pop-up body (I) into the sink. Screw
the ange (F) onto the pop-up body (I). The
pivot hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (H),
but do not over tighten. Do not turn the pop-up
body (I) while tightening the nut (H) or the
sealant may not seal properly. Clean away any
excess putty.
E
6
F
I
1
H
N
L
K
J
1