Publicidad
RTA-2202
4
31
5
5
Set aside the flat sliders (7), they are used until the next step. Turn drawer upside-down and
assemble the "L" type sliders (7) to the side panels of the drawer (2) & (3), making the holes align
with the pre-drilled holes, and with the wheels facing to the back, then fix them with screws (G).
Make sure the sliders are in contact with the side panels, and that there is no part of them "up in
the air".
Separe los deslizadores planos (7) para ser usados hasta el próximo paso. Vire la gaveta hacia abajo
y ensamble los deslizadores (7) tipo "L" a los paneles laterales (2) y (3), haciendo coincidir los agujeros
con los pre-taladrados y con las ruedas en la parte trasera, luego fíjelos con los tornillos (G).
Insert the Tubes for Files (31).
Inserte los Tubos Porta Carpeta (31).
WARNING: Do not overtighten the tubes as they may perforate
and damage the front panel. Such damage is not covered by the
product's warranty.
ADVERTENCIA: No apriete los tubos demasiado porque pueden
perforar y dañar el panel frontal. Este tipo de daño no está cubierto
por la garantía del producto.
Right
7
Left
7
2
P.10
SCREWS
TORNILLOS
G
3X15 MM
4PCS
Publicidad
