Axis A1001 Guia De Instalacion página 5

-
-
Specifications
•
Operating conditions
-
•
Wire area
-
-
•
Connectors
-
-
-
-
•
System considerations
Users shall not replace
the battery. If the battery
needs replacing, a factory
trained service professional
shall contact Axis support
at www.axis.com/techsup for
assistance.
Used batteries shall be disposed
of according to local laws and
regulations, which may vary
from state to state. Waste
BR/CR lithium cells are neither
listed nor exempted from
the USEPA hazardous waste
regulations. Waste lithium
batteries can be considered
reactive hazardous waste if
there is a significant amount
of unreacted, or unconsumed
lithium remaining. For
information about how to
dispose of used lithium
batteries, contact your local
authority for waste disposal.
Temperatures
0 °C to 50°C (32 °F to 122 °F).
UL Listed or R/C AWM wires
that have an conductor gauge
range of AWG 22–14 shall be
used.
The minimum conductor gauge
for connection between the
power sourcing equipment
(PSE) or power injector and
the powered device (PD) is
26 AWG.
This product is not intended
for outside wiring as covered
by Article 800 in the National
Electrical Code, NFPA 70.
Power connector – For UL
security applications, the
product shall be powered by a
UL 294 Listed or UL 603 Listed
Class 2 low-voltage power
limited power supply that is
capable of 4 hours of standby
power.
Network connector – Power
over Ethernet (PoE) shall be
supplied by a UL 294 Listed
Class 2 power limited injector
that provides 44–57 V DC,
15.4 W and 4 hours of
standby power. Compliance
with IEEE 802.3 (at or af)
specifications has not been
verified as part of UL 294/B.
Tampering alarm pin
header – To comply with
UL 294/7.2.1 (Enclosure), the
tampering alarm shall be
connected to a sound alarm.
-
•
Wall and ceiling mount
-
•
Assign an IP address
-
•
Maintenance instructions
-
•
Further information
-
The Axis product, whether it is
a standalone door controller or
a system of door controllers,
shall not impair the intended
operation of the panic
hardware used in conjunction
with it.
If using a junction box to
mount the Axis product, the
junction box shall be UL Listed.
The functionality of AXIS
Device Manager, see the
User Manual, has not been
evaluated by UL.
For maintenance instructions
(some steps require access
to the product's webpages),
see the User Manual. For
information about how to
configure the Axis product
using the product's webpages
(AXIS Entry Manager), see the
User Manual.
Firmware version: Door
Controller, Model A1001 –
1.20.2