Testing Operation - TomTom LINK Guia De Instalacion

EN

Testing operation

Test Power/Ignition test
ing
oper
atio
n
Here you test the connection to power and to
ignition. Before testing make sure you have
carried out the steps described in the previous
chapters.
1. Please check all connections to TomTom
LINK (wires, fuses and antennas).
2. Check that the SIM Card is inserted
correctly.
3. Make sure the ignition is turned off.
4. Disconnect the terminal cable (and IO cable
if used).
5. Disconnect the power supply for a few
seconds.
6. Reconnect the power supply.
The green GPS LED must not be off. After
about 60 seconds all LED's must switch off.
7. Now turn on the ignition.
At least the green GPS LED must not be off.
Otherwise, check all connections and
repeat the test.
GSM / GPS antenna test
For this test, you may need to move the
vehicle to a location with a clear view of the
sky to facilitate adequate GPS and GSM
reception. For details see the table under
'Diagnostics'.
1. Turn on the ignition.
2. Monitor the yellow GSM LED and green the
GPS LED. Both will start flashing.
3. The yellow GSM LED will switch off if the
device is successfully registered with the
GSM network. The green GPS LED will
switch on if the device has obtained a valid
GPS position.
4. After 10 minutes the yellow GSM LED must
be off and the green GPS LED must be on.
If the yellow GSM LED keeps flashing,
check if the SIM-card is inserted correctly
and if the GSM antenna is connected and
installed in a proper position. If the green
GPS LED keeps flashing, check the GPS
antenna connection and position.
16