Linking To Tomtom Webfleet - TomTom LINK Guia De Instalacion

Linking After you have successfully performed the
to TomTo
m
WEBFL
basic test and the GSM / GPS antenna test you
EET
are ready to start the TomTom WEBFLEET
linking process. After successful linking, the
vehicle will be available in the customer's
TomTom WEBFLEET account with a valid first
position report.
Before starting the linking process, the
TomTom LINK serial number and the SIM ID
must have been registered. Visit
www.tomtomwork.com/activate and follow
the instructions to register. To start the linking
process:
1. Turn on the ignition and monitor the LED's.
The red SYS LED will be permanently on,
yellow and green will start flashing.
2. Wait until the yellow GSM LED is off and
the green GPS LED is on.
3. Press the reset button.
The red SYS LED will start flashing. During
the linking process, the yellow GSM LED
will be switched on to indicate GPRS
connection.
4. If the red SYS LED is switched off, the
linking process is completed.
5. If the red SYS LED stops flashing and
remains on, an error occurred during
linking. Make sure the TomTom LINK serial
number and the SIM ID have been

Linking to TomTom WEBFLEET

registered with TomTom WEBFLEET and
the basic tests were completed
successfully.
17
EN