MagicTouch MT400
Please observe the following instructions for batteries:
WARNING!
!
Children could swallow batteries. Keep the batteries out of reach of
children.
Only use leak-proof batteries that are suitable for electronic devices.
Never attempt to do the following with batteries:
– recharge them,
– open them or
– throw them in fires.
To replace the batteries, proceed as follows:
➤ Remove the screw on the back of the hand-held transmitter and open the
transmitter.
➤ Replace the battery.
Make sure that the polarity is correct when you insert the battery (battery
type CR 2032 3 V). The positive terminal is at the top.
Batteries are available e.g. in photo shops, clock shops, etc.
➤ Refit the lid on the hand-held transmitter and re-insert the screw.
9.3
Learning or deprogramming the hand-held trans-
mitter
See fig. g
MagicTouch can be operated using up to 10 hand-held transmitters. If a new
hand-held transmitter is to be learned, all other transmitters will have to be
paired again.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
➤ Use a hand-held transmitter to open the vehicle.
➤ Take a seat in the vehicle and leave the door open.
➤ Switch on the ignition.
➤ Press and hold the "comfort" button on a hand-held transmitter already
paired.
Operating MagicTouch
37