Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso página 40

Operating MagicTouch
➤ Switch the ignition off.
➤ Let go of the button.
✓ The status LED and the hazard light flash 10 times, after which they are
continually lit.
✓ The system is now in learning mode.
NOTE
I
If you do not press a button within 10 seconds, you will exit the
learning mode.
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this
learning phase. This also applies for the hand-held transmitters which you
have already been using!
➤ Press the "Comfort" button on the hand-held transmitter.
✓ The status LED and the hazard lights go out while the value is being
saved.
✓ If the status LED and the hazard lights light up continually again after
2 sec., then the hand-held transmitter has been paired and you can now
learn the next one.
NOTE
I
Only exit learning mode when you have paired all hand-held trans-
mitters which you wish to use. Hand-held transmitters which you do
not learn during this pairing phase will be automatically depro-
grammed from the system. They can only be used again once they
have been relearned.
To exit learning mode:
➤ Switch on the ignition.
Testing the hand-held transmitter
➤ Test the new hand-held transmitter.
If a hand-held transmitter does not function, then they must all be learned
again.
38
MagicTouch MT400