Parts And Maintenance - Ingersoll Rand 41 Serie Especificaciones Del Producto

EN
Clutch Adjustment
External
1. Rotate Sleeve until opening in Housing is visible.
2. Depress bit to engage clutch, then rotate until notch in Adjustment Washer or is visible.
3. Insert No. 1 Phillips screwdriver in notch to turn gear teeth on Nut.
4. Turning clockwise will decrease torque.
5. Turning counterclockwise will increase torque.
Internal
1. Remove Clutch Housing, Bit Holder and Clutch Assembly from tool.
NOTICE
Clutch housing has left-hand threads.
2. With bit in Bit Holder, clamp bit in vise.
3. Place Clutch Assembly on Bit Holder.
4. Engage jaws, hold Clutch Assembly from turning. Then rotate Adjustment Nut with 7/8"
wrench.

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2 80167356_ed2