Publicidad
Franke care instructions.
• Periodically clean the aerator filter;
• Install filter valves under the sink and periodically clean the filters;
• DO NOT USE DETERGENTS, SOLVENTS, CHEMICAL AGENTS, ABRASIVE
SPONGES, WIRE WOOL OR ALCOHOL, ETC., which would irreparably damage
the surface of the product and ruin its appearance, sheen and matt finishes;
• CLEAN WITH SOAPY WATER AND DRY WITH A SOFT CLOTH;
• Dry the product after use if the water is very hard or aggressive, as it may
leave deposits which would damage the surface;
• Do not install the tap when the water pressure exceeds 500 kpa (in this case
* Valido solo per l'Italia - Only for Italy - Nur für Italien -
pressure limiting valves are required);
Seulement pour l'Italie - Solo para Italia
• Rinse the water pipes before installing the tap.
Cartridge
1950521
1950521
Hose for Hand
shower 1950481
Per l'acquisto dei ricambi rivolgersi ai Centri Assistenza Franke.*
Per informazioni numero verde 800 - 359 359.
Technical Information
• Maximum hot temperature 80° (Recommended 65°)
• Maximum operating pressure 75 psi / 500 kpa
• Minimum operating pressure 7.25 psi / 50 kpa
• Ceramic cartridge
5 A n n i d i G a r a n z i a
5 Ye a r s W a r r a n t y
1950319 Cromo
1950320 Satinato
1950321 Avena
1950322 Grafite
1950323 Sahara
Chrome Handle
1950396 Alluminio
1950319
1950480 Cromo
1950503 Satinato
1950504 Avena
1950505 Grafite
1950506 Sahara
Hand Shower
1950507 Alluminio
142/133
1950481
Franke installation instructions.
Flexible Hose
203/95 + 203/96
- Close the water.
- Place the washer 2 on the base of the sink 1.
- Introduce the body 1 into the sink hole.
- Introduce the washer 3 under the sink.
- Place the fixing plate 4 under the sink.
- Tighten the whole by screwing firmly the fixing nut 5 to the stem of the body 1, and keeping
the spout turned 70° to the left, corresponding to the stop.
- The tap must be placed in the central position respectively to 140° rotation.
- Connect the flexible 7 to the flexible 9 with washer 8.
- Place the load weight 10 on the flexible 9 with the screw 11.
- Connect the flexibles 6 (red hot water, blue cold water) to the water supply-pipes or to filter
taps (not included in the packaging).
- Do not install the flexibles in tightness and twisting conditions during the rotation, to permit
free rotation.
- Open the water.
1
Outer casing
2
Dress ring washer
3
Rubber seal
4
Under sink washer
5
Brass fixing nut
6
Flexible connector
7
Pull out hose
8
Washer
9
Weight connector
10
Counter weight
11
Locking screw
12
Hand shower
Publicidad
