Russell Hobbs 18553-56 Instrucciones página 3

diagrams
1 speed control
2 arm release
3 motor unit
4 rear drive cover
5 arm
6 front drive cover
7 splash guard
8 bowl
2 Unplug the appliance before assembly, disassembly, or cleaning.
3 Unplug the appliance before fitting or removing attachments.
4 Don't leave the appliance unattended while plugged in.
5 If the cable is damaged, it must be replaced by the manufacturer,
its service agent, or someone similarly qualified, to avoid hazard.
L Don't put the motor unit in liquid.
6 Don't use the appliance without fitting the splash guard.
7 Don't run the motor continuously for more than 10 minutes, it may overheat. After 10
minutes switch off for at least 10 minutes, to recover.
8 Switch off (0) before fitting the jug to the motor unit.
9 Don't use accessories or attachments other than those we supply.
10 Don't use the appliance for any purpose other than those described in these instructions.
11 Don't operate the appliance if it's damaged or malfunctions.
C SWITCH ON
1 Sit the motor unit on a dry, firm, level surface, near a power socket.
2 Check that the speed control is set to 0.
3 Put the plug into the power socket.
C SPEED CONTROL
4 Turn the speed control to the speed you want (1 = low, 10 = high).
5 Turn the speed control back to 0 to turn the motor off.
6 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
7 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
Y PULSE
8 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
v USING THE STAND MIXER
9 The springs in the arm are quite powerful, so:
a) Check that the appliance is switched off (0)
b) Hold the bottom of the appliance.
c) Keep clear of the top of the arm.
d) Turn the arm release to U.
e) The arm will move to the raised position.
f) Let go.
9 lid
10 hook
11 whisk
12 beater
13 slot
14 lug
15 latch
16 drive
17 drive shaft
household use only
3
18 rear drive
19 jug base
20 blade unit
21 seal
22 jug
23 handle
24 lid
25 cap