Publicidad
Idiomas disponibles
Idiomas disponibles
The kit consists of:
1. Before fitting the air kit set knock out the steel plate (1) in the insert box. This is best done
by applying gentle hammer taps immediately onto the small "bridges" in the circular cut-
outs.
2. Remove cast combustion chamber from the convection box and unscrew the control bar (4)
from the cast iron base fastened with the screw (5) in the middle.
Now place the cover plate (3) around the air slide fitted (6) at the back of the stove (see dra-
wing). Refit the control bar (4) on the cast iron base plate.
3. The 4 M6x8 screws fitted at the back of the cast iron plate, where the air kit box is to be
fastened, are removed.
4. Paste the tape (7) to the edge all around the air kit box.
5. Remove the 4 M6x8 (2) screws located at the back of the cast iron plate where the air kit box
is to be fitted. Make sure that the cover plate (3) is fitted correctly inside at the bottom of the
box. (see drawing).
The stove can be installed. See the enclosed Instructions for installation and use.
1
Installation Instructions
Morsø 5660 Outside Air Kit
1 pcs. Outside Air Box
1 pcs. cover plate
2 pcs. screws 6x35 mm
2 pcs. screws 6x55 mm
110 cm tape
2
2
2
7
Ø127
Ø108
2
6
3
4
5
b
Påført glastape
Rev.
Revisions
Publicidad
