Scosche STUCKUP WIRELESS Manual Del Usuario página 4

TRANSMITTER
PLACEMENT IN
VEHICLES
It is possible for the transmitter
to interfere with some wireless
systems w1th1n a car. Specifically,
key fobs with immobilizers,
keyless start systems or tire
pressure monitors. Therefore, it
is recommended to test the location
of your transmitter before deciding
on final placement. Most interference issues will be
minimized by considering the following placement guidelines:
• Install transmitter a minimum of 10 inches away from the
ignition lock, key fob docking station, or any location where
the key fob might be stored while driving.
If the transmitter cannot be located a sufficient distance
away as described above, please use the following
suggestions whenever possible:
• Insert the key fob into the docking slot whenever possible
while operating the transmitter.
• Connect the transmitter to a 12 volt accessory port that is
powered only while the vehicle's ignition is in the "ACC" or
"ON" position.
• Place phone on transmitter after vehicle is started.
'<i'=":::;::..,,,
4