English; Intended Use - GCE UNISET Instrucciones Para El Uso

ENGLISH

INSTRUCTION FOR USE: OUTLET POINTS FOR INDUSTRIAL USE
1 .
FOREWORD
EN
The product complies with the essential requirements of standards for central-gas supply equipment relating to
industrial and technological processes.
Handling of technical gases requires the knowledge of technical standards, rules and directives for compressed,
liquefied and high pressure dissolved gases with regards to the following directives:
•
PED 97/23/EC European Pressure equipment directive.
•
ISO 7291 Gas welding equipment – Pressure regulators for manifold systems used in welding, cutting and
allied processes up to 300bar.
•
ISO 14114 Gas welding equipment – Acetylene manifold systems for welding, cutting and allied processes –
General requirements
•
ISO 15615 Gas welding equipment – Acetylene manifold systems for welding, cutting and allied processes –
Safety requirements in high-pressure devices.
•
EN 730-1 Gas welding equipment. Safety devices. Incorporating a flame (flashback) arrestor
•
ISO 5175-1 Gas welding and cutting equipment and allied processes -- Safety devices for fuel gases and
oxygen or compressed air -- Part 1: General specifications and requirements
•
ISO 9090 Gas tightness of equipment for gas welding and allied processes.
•
ISO 9539 Gas welding equipment – Materials for equipment used in gas welding, cutting and allied processes.
•
National rules, directives, norms and regulations must also be complied with.
2 . 2 .

INTENDED USE

The outlet points are used for industrial applications.
3 .
OPERATIONAL, TRANSPORT AND STORAGE REQUIREMENTS
Keep the product and its associated equipment from:
•
heat sources (fire, cigarettes, . . .),
•
flammable materials,
•
oil or grease (especially be careful in use of hand cream)
•
water
If the outlet point is stored at temperatures below -20°C do not use the manifold until its temperature reaches
at least -20°C.
National laws, rules and regulations for compressed gases, accident prevention and environmental protection
must be observed.
OPERATION CONDITIONS
-20/+60 °C
10/100%
KEEP DRY!
KEEP AWAY FROM OIL AND
GREASE!
STORAGE AND TRANSPORT CONDITIONS
4/76
-40/+60 °C
10/100%
KEEP DRY!
KEEP AWAY FROM OIL AND
GREASE!