All manuals and user guides at all-guides.com
PROPER CARE & CLEANING
General Cleaning
Perform: As needed
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1.
Clean cabinet surfaces with a soft cloth and warm soapy water, then rinse.
2.
Wipe dust from back of dispenser to improve efficiency.
3.
Remove drip tray assembly by pulling it forward. Remove cover. Place tray and
cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water.
Cleaning Cold Reservoir and Water Lines
Perform: Every 3 months or whenever an off-taste occurs.
Time Required: 15 minutes.
Note: Best to do prior to loading a fresh bottle.
1.
Unplug power cord from wall outlet.
2.
Remove water bottle.
3.
Unclip Wall Mount Strap from back of dispenser and turn dispenser around so
backside is facing away from the wall.
4.
Place a 2 gallon or larger bucket under the drain
plug in the rear of the dispenser.
Remove drain cap and silicon plug. Cold water will
immediately flow into the bucket. This will be
followed several seconds later by hot water at
temperatures that can cause severe burns. Avoid
direct contact with hot water. Keep children and
pets away while draining unit.
Reminder - Place drain cap and silicon plug in a
safe location so they are not lost.
5.
Remove remaining water from cold reservoir by
dispensing from both taps into a pitcher.
6.
Remove probe assembly by turning it counter clockwise.
7.
Remove plastic baffle from inside reservoir.
Model # 900138: Page 9