4
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Insert four Wood Dowels (4) into the inner holes of the Bottom Panel (C). Tap in with a rubber mallet, if
necessary. Make sure that you use a small amount of glue with both ends of all dowels.
NOTE: It is very important to use a small amount of glue on both ends of dowels.
3. Glue two Wood Dowels (4) into the inner holes of each Top Stretcher (D).
Assembly Instructions
C
4
④ x 8
4
4
4
D
5
4
x 2