Jasco myTOUCH SMART Guia De Inicio Rapido

In-Wall
Motion-Sensing
Switch
Specifications
120VAC 50/60Hz
15A resistive
1200W tungsten
5A/600W electronic ballast/LED
1/2HP motor
Installation instructions
If you are uncomfortable with installation, contact a qualified
electrician.
• For supply connections, use 14AWG or larger wires suitable for at
least 75° C.
• For grounding lead use 12AWG or larger wires suitable for at least
75° C.
• Tighten wire connections to 12.4lbf-in. (5.6kg).
• Use copper wire only.
• Recommended wire-strip length – 5/8in. (16mm).
• Use screw-terminal holes – do not wrap wires around screws.
• Indoor single-pole installation only.
1. Turn power off at circuit breaker or fuse box before installation.
2. Remove wallplate and switch from switch box.
3. Identify the line, load, neutral and ground wires.
4. Connect the green or bare copper ground wire to the GROUND
terminal.
5. Connect the black line (hot) wire to the LINE terminal.
6. Connect the black load wire to the LOAD terminal.
7. Connect the white neutral wire to the NEUTRAL terminal – use
provided jumper if needed. Often the neutral wire (white) can be
found in the back of the wire box connected with a wire nut.
8. Insert the motion-sensing switch into the switch box being
careful to not pinch or crush wires.
9. Secure the switch to the switch box using the provided
mounting screws.
10. Replace door if light-almond color is desired. Insert a flat-blade
screwdriver into either groove in the lower corner of the sensor
and gently pry up the door. Repeat on the opposite side to
remove the door from the sensor. Align the hooks of the
replacement door with the hooks at the bottom of the sensor
and snap the bottom tabs into place.
11. Install a rocker-style wallplate – not included.
12. Turn the power on at the circuit breaker or fuse box.
Works with dimmable
LED and CFL bulbs.
41381 WIRING MANUAL V1
04/08/20
MADE IN CHINA
Distributed by Jasco Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a 1-year limited warranty.
Visit www.byjasco.com for warranty details product registration.
Questions? Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM—8PM, M-F, Central Time.
Typical SPST Installation
Figure 1
Black
TOP
Load
LOAD
Black
NEUTRAL LINE
GROUND
Green
Ground
JUMPER WIRE
White
Neutral
Load
= Wiring Nut
Black
Line
NO
120VAC
Line
Power
Load
C
Source
White
White & light almond
faceplates included
RISK OF ELECTRIC SHOCK
• SHUT OFF POWER AT FUSE BOX OR
CIRCUIT BREAKER BEFORE INSTALLATION
• DO NOT USE IN WET LOCATIONS
• USE INDOORS ONLY
RISK OF FIRE
• DO NOT USE TO CONTROL APPLIANCES
THAT CONTAIN HEATING ELEMENTS
(COOKING APPLIANCES, HEATERS, IRONS,
ETC.)
• DO NOT EXCEED ELECTRICAL RATINGS
• USE COPPER WIRE ONLY WITH THIS
DEVICE
• DO NOT USE TO CONTROL RECEPTACLES
Line
Black
Black
Light
White
WARNING