Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pickup Bed Installation
1.
Install pickup bed
•
Ensure the locating pins shown in figure 9 are properly installed to both the pickup frame and pickup
bed to prevent misalignment.
2.
Tighten the eight bolts to 129 ft-lbs (175 Nm).
FIGURE 9
3.
Install the fuel filler pipe and tighten to 44 in-lb (5 Nm).
4.
If equipped, install the urea filler pipe and tighten to 22 in-lb (2.5 Nm).
5.
Reconnect the LH and RH wire harnesses.
6.
Install the tailgate onto the pickup bed.
7.
While inside the pickup bed, inspect the fifth wheel hitch for proper puck placement.
•
Puck grooves should sit above the drilled holes.
•
There should be a minimum 0.039" (1mm) clearance between the pucks and holes in the pick up bed.
FIGURE 10
8.
Clean any debris from pickup bed
9.
Check the vehicle exterior lighting for proper operation.
©
2019 Horizon Global
30886N
Page 7 of 8
6/24/19
Rev. B
Publicidad
Tabla de contenido
