Installation; Preparing For Installation - Glacier bay HD65601-8004 Guía De Instalación Y Cuidado

Installation

1

Preparing for installation

CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Drill holes in the nished deck as shown in
the diagram below.
NOTE: This kit allows up to 1-7/8 in. deck thickness.
1-3/8 in.
Diamter
3
Installing the spout assembly
□
Insert the spout assembly (A) through the hole
in the deck.
□
Secure the spout assembly (A) with the rubber
washer (B), metal washer (C) and mounting
nut (D).
1-1/8 in.
Diamter
1-3/8 in.
Diamter
2
Removing the mounting kits
□
Remove the clip (F) and T-tube (E) from the
spout assembly (A).
□
Loosen the mounting nut (D) and remove the
washers (B & C) from the spout assembly (A).
B
C
D
B
C
D
4
A
E
F
A