Troubleshooting - Novital Covatutto 24 Instrucciones Para Uso Y Mantenimiento

TROUBLESHOOTING

Phase Situation
Incubation Misting of the cover and/or of the
porthole, with subsequent formation
of droplets.
Egg-hatching Misting of the cover and/or of the
porthole, with subsequent formation
of droplets.
Incubation / No supply of electrical power for some
Egg-hatching hours.
Incubation / No supply of electrical power for more
Egg-hatching than 5-6 hours.
In case of irregularities while operating, warning lights (analogue models) may turn ON or error messages may be shown in
the display of the incubator (digital models).
ANALOGUE MODELS
NOVITAL
Position of the warning light in analogue incubators.
Messages Problem Solution 1
Lamp Wait a bit before adjusting the
Low temperature
always ON or temperature.
or
always OFF
high temperature
Try to adjust the temperature in the
modes that are speci ed for each
Green lamp
individual machine (see
xed or OFF
Red lamp Turn o the
General problem
machine and
ashing
call Novital or
an authorised
Service Centre
30
Advice
Open the incubator for a few minutes to
balance the humidity.
Check the environment temperature.
It is normal that the cover and/or the porthole
get wet. Do NOT open the incubator to prevent
reducing the humidity level.
DO NOT open the incubator, to slow down
temperature lowering inside the machine.
Move the incubator to a su ciently warm place.
Leave the cover open to let the heat enter the
device, so that the eggs do not cool down.
Solution 2
Turn o the
machine and
call Novital or
an authorised
Service
).
Centre
DIGITAL MODELS
NOVITAL
Position of the display in digital incubators.
Messages Solution 1
Disconnect the plug from the mains socket for a few
seconds, and then connect it once more (if necessary,
repeat the operation).
If the irregularity persists, call an authorised Service
Centre.
Replace the temperature probe at an authorised Service
Centre.
Replace the temperature probe at an authorised Service
Centre.
The temperature inside the incubator is too low.
Check:
- temperature of the premises
- prolonged opening of the incubator
- possible breaking of the heating element/s.
Call an authorised Service Centre for the possible
replacement of the heating element/s.
The temperature inside the incubator is too high.
Call an authorised Service Centre to solve the problem.
GENERAL FINAL NOTE:
For further information and explanations,
visit the web-site: www.novital.it
www.novital.it
Solution 2
If Solution 1 proves to be
ine ective, call Novital or
an authorised Service
Centre
31