Installation Requirements - MaxLite ML7LA4S30 Serie Instrucciones De Funcionamiento

Operating Instructions
MaxLite LED Desk Lamp
®

Installation Requirements

• Select a suitable location for the fitting;
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the fixture.
- Ensure the fixture is not installed next to any air vents and is not in any moist or damp areas.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Check whether the fitting has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
• Do not plug into the main power socket outlet before or during assembly. Only do so after the portable lamp is
fully assembled and ready to use for the first time.
Installation Directions
1.
Remove all packaging material from the product.
2.
Select a suitable location for the light fitting. See the installation requirements above.
3.
Adjust the head of the lamp to the desired angle.
4.
Insert the fixture plug into a properly grounded outlet. Ensure it is fully plugged in.
5.
Use switch on base to turn the lamp on/off.
6.
To use USB, insert compatible USB plug.
NOTE: When adjusting the head of the lamp, do not adjust more than the 45° angle shown above, as this
may damage the adjustable joint and the internal wires.
Warranty
MaxLite offers a warranty on this product, please see:
http://www.maxlite.com/resources/warranties for more information.
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
Max 5V, 1.0A
USB Charger Port
EI puerto de carga de USB
Le port USB de charge
LED Desk Lamp
Page: 2
REV: 12/09/20