•
Connect the exhaust hose adapters with one end each of the exhaust hose by turning. Then, fix the
exhaust hose at the back of the portable local air conditioner (see pic.2).
•
Temporary exhaust hose installation: Please lead the free end of the exhaust hose out of the window
(see pic.3).
•
Exhaust hose installation with window kit: Depending on your type of window, insert the window kit
horizontally or vertically into your window. Lead the exhaust hose through the hole at the window kit
(see pic.4).
Pic.1
Operation
•
After switching on or switching over, the fan runs. The compressor and cooling capacity start as soon
as the set temperature in cooling mode is lower than the room temperature.
•
Operating voltage: 220-240V~, 50Hz
•
Control panel:
On/Off
Temperature +
•
Remote control:
•
The unit reaches the following temperatures during operation:
Maximal Cooling: in dry environment 35°C, in wet environment 24°C
o
Minimal Cooling: in dry environment 18°C, in wet environment 12°C
o
•
Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER" to turn on the unit.
•
If you use the cooling and dehumidification functions, please keep an interval of at least 3 minutes
between the two operations.
Drainage hole
Pic.2
Display
Temperature -
Signal receiver
remote control
1. SPEED:
2. TEMP+:
3. MODE:
4. TEMP-:
5. TIMER:
6. POWER:
Operation with 2 x AAA batteries (excl. scope of delivery)
Pic.3
Operation mode
Ventilation speed
Ventilation speed
Temperature +
Operation mode
Temperature -
Timer
On/Off button
Pic.4
Timer