Assembly And Operation - Bestway 58482 Manual De Instrucciones

Assembly and Operation

WARNING For Charging
· Use only the original external adaptor and provided charging cable.
· Make sure the robot and the charger port are clean and dry before set-up.
· Make sure that the robot is turned off by sliding the switch to OFF position prior to charging.
· Fully charge the robot (about 5-6 hrs) before using it for the first time.
· Power indicator light : No light - Power off / no power
Light - Power on
Blinking light - Battery power will cease within 10 minutes.
Note:
Once the robot begins charging, the indicator light on the external adaptor will turn red. When the robot is almost fully charged, the indicator light will turn green.
1
5 6
2 4
Left
7
8
8.4
Note:
Pry to detach the float cover and release the rope from the float to the depth of pool water plus about 0.5 m(19.7 in.).
303021219122_58482_21x28.5cm_ 欧规池底清洁机器人说明书 _ 英
2
Fixed locking pin
Left
Right
Factory setting of the pin for all types
of pool.
8.1
8.5
3
Right
If the robot trajectory is too curved,
pull out the pin and insert it in this
hole. Make sure the wheel axle is
positioned below the axle.
8.2
4
4
4.5-5 h
RED light – Charging
GREEN light - Charged
To increase the curve of the trajectory,
remove the pin from the hole and
insert it in the hole which is located
above the pin hole as shown.
8.3
8.6