Maintenance And Storage; How To Remove The Battery Pack - Bestway 58482 Manual De Instrucciones

Ocultar thumbs Ver también para 58482:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Note:
1. It's advised to turn off the filtration system as water circulation in pool may affect the robot movement pattern.
2. Move pool ladder, surface skimmer and other floating objects from the pool as it may obstruct the movement of the robot's float and, consequently, also the
movement of the robot.
3. If you are using saltwater pool, make sure all salt is dissolved before placing the robot into the water.

Maintenance and Storage

1. Battery discharges on its own during storage. Make sure to fully-charge the robot before storage.
2. You must re-charge the battery at least once every three months when it is not in use.
• Unplug the external adaptor from the socket and then unplug the charging cable from the external adaptor and robot.
• Detach accessories from the robot. If necessary, rinse the robot and accessories with fresh water. DO NOT use detergent.
• Be sure to drain the water from the robot before storing it.
• Use a damp cloth to clean and dry the robot and its accessories.
• Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool chemicals and from children. Ambient temperature for storage should be 10˚C – 25˚C
NOTE:
(50˚F – 77˚F).
A higher storage temperature may reduce the battery life.

How to remove the battery pack

Recommended tools (not included): Screwdriver.
1. Release the top cover (preassembled with the swivel head). Turn the cover up side down
and release the swivel head by turning its bottom locking plate counter-clockwise. Remove
the swivel smoothing-ring.
2. Use the screwdriver to unscrew the 4 screws located on the bottom of the head to release
the bottom plate at first. Use the screwdriver to unscrew all the screws on the base as shown.
Remove the impeller and then pry up the base and remove it to expose head inside.
3. Remove the battery pack to expose the PCBA. To detach the battery connection wire,
press the clip on the connector and then pull it out. NOTE: Wrap the connector immediately
with insulating tape in order to avoid short circuit caused by contact of both wire terminals.
DISPOSAL
Meaning of crossed -out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the
collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the
food chain, damaging your health and well-being. When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for
disposals at least free of charge.
303021219122_58482_21x28.5cm_ 欧规池底清洁机器人说明书 _ 英
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Flowclear 58482

Tabla de contenido