Install The Hardware - Axis P3905–RE Guia De Instalacion

TX-
DC+/DC-
RX+
DC-/DC+

Install the Hardware

Important
AXIS P3905–RE must be mounted on a flat surface.
Note
Camera angle adjustment for P3905–RE:
• Pan ±20°
• Tilt 0-15°
• Rotation ±175°
1. Use the supplied drill template and drill four holes for the
bottom cover screws and one hole for the network cable.
Note
When using the drill template, make sure it conforms to the
desired angle of the camera installation.
2. Remove the top cover from the bottom cover, using the top
cover tool. See image 1.
AXIS P3905–RE Network Camera
13