Troubleshooting - Sonic Impact Technologies i-F2 Guía De Usuario

SPECIFICATION
The excellent sound quality of the i-F2 comes from our highly professional design, which includes a
customized Hi-Fi Neodymium driver, digital amp, and the latest digital equalizer circuitry
Specifications:
Power output: 2W*2
Speaker channel： 2 channel stereo output
Impedance： 12Ω
Frequency：120Hz-20KHz
Signal to noise ratio: 85dB±2 (0.5M & 1W)
Speaker Drivers：neodymium- magnetic drivers @ 1.25" X 4
TROUBLE SHOOTING
SYMPTOM POSSIBLE PROBLEM SOLUTION
Power Power is not turned on Position the power switch to the "on" position.
LED not
Universal power supply Plug the universal power supply into a wall outlet and plug
lit when
cord isn't connected to the power supply connector into AC input jack on the side of
AC
a wall outlet and/ or the i-F2 system.
adapter
the power supply
plugged connector is not
in plugged into jack on
the back of the i-F2
system.
Surge protector (if If the universal power supply cord is plugged into a surge
used) isn't powered protector, make sure the surge protector is switched on.
on.
Wall outlet is not Plug another device into a wall outlet (same outlet) to
functioning. confirm the outlet is working.
All manuals and user guides at all-guides.com
SYMPTOM POSSIBLE PROBLEM SOLUTION
The Warning: Charge Charge the batteries before re-playing i–Fusion system.
battery required.
life
indicator
at the left
end turns
red
Remote Remote t is out of the Remove it to the valid scope
no valid scope
function
Some object disturbs Remove the object or remove the remote to the valid scope
between the i-F2 and w/o any disturbance between.
the remote
The battery inside the Replace the battery(Refer to the illustrations in the Quick
remote is dead Connect instruction for detail operation)
No sound Power is not turned on. Verify the universal power supply cord is plugged into a wall
from the outlet and the AC input jack on the side of the i-F2 system.
speakers
Verify rechargeable battery is charged if the universal power
supply isn't being used.
Verify the power switch has been positioned to the "ON"
position, the stand-by button has been pushed and the LED is
illuminated.
Volume is set too low. Press the "+" button to increase the volume.
Check volume level on alternate audio source device and set
at mid-level.
iPod is not seated into Remove iPod and re-seat it in the docking station.
the docking station.