Logitech Mobile Speakerphone P710e Guia De Inicio Rapido página 7

Initial setup of device
• The very first time you use the P710e,
you must connect it to a USB power source.
• Adapter not included.
USB
Setup with a computer
• Connect the USB cable from the P710e
into your PC.
• Ensure that the P710e is selected as
the default audio device in your OS settings
and in your application.
Logitech Mobile Speakerphone P710e
Setup with a Bluetooth device
• Press and hold Power button to turn ON
the device. The blue lights start flashing in
a clockwise circle.
• Place your mobile device in pairing mode
and pair to the P710e. You may pair up to
eight Bluetooth devices with only two active
at the same time.
• If you have an NFC enabled device, position
it near the NFC target area on the P710e.
You should see a message on your phone
asking if you would like to pair to the P710e.
– P710e must be powered on.
– Note, position your NFC enabled device
near the NFC target area a second
time to disconnect from the P710e.
This is helpful if you're still in range
of the P710e, but want to handle calls
on the mobile device.
USB
– Repeat the procedure again
to reconnect.
English 7