Power Supply Unit - Maytronics MTC8-UNI Instrucciones De Uso

English

3. Power supply unit

Digital, "Switch-Mode" power supply:
Input - 100-250 AC Volts
50-60 Hertz
180 Watt
Output - 30 VDC
IP 54
Section 2 – Robot Pool Cleaner Operation
Part 1 – Preparing the Robot Pool Cleaner for Use
A. Assemble the Caddy kit – you will find the instructions in a separate document
B. Adjusting the handle float angle
The handle angel must be adjusted to determine the speed that the robot pool cleaner advances along the water-line
1. Lay the handle down at an angle of 180º
to the ground.
2. Push the base of the arm into the body
of the robot pool cleaner and slide it towards
the rear of the robot pool cleaner until it clicks
into the required position.
Normal advance
More efficient cleaning action on water-line.
Fast advance
Fast speed – For faster but less efficient cleaning
action on water-line.
On/Off
switch
Push in here
Slide here
Bag Indicator
Reset button
Slide here
Push in here
2
Full Filter Delay
Indicator