Cleaning And Maintenance - Adler europe AD 6513 Manual De Uso

„ „.
Only Child Lock button and On/Off button are available. Press and hold the Lock Button for 3 seconds to cancel the lock
function.
10. Warm function. Press the Warm button (5), the display window shows the default temperature 60℃. The temperature cannot be
adjusted.
11.Max power function. If you wish to make the cookware's temperature increase faster for cooking, press the Max Power Button (4).
The indicator above this button will light and cooktop will start the maximum power level for heating. The display window shows the
power level "P9".
12.Press the On/Off Button to turn the unit off when finished cooking.
IMPORTANT NOTES
NOTE: If the cookware is removed from the induction cooker at any time during the cooking cycle, the unit will beep continually for 30
seconds, error code E0 will appear in the Display Window and the unit will shut off automatically
NOTE: When the unit is turned off, the fan will continue running and the display window will also display `H' until the temperature of the
Induction Cooker is below 50℃.
NOTE: Cookware bottom diameter should be no less than 12 cm or more than 22 cm in order to work correctly. If the Cookware is
larger than the circular cookware placement guides indicated on the Induction Cooker, the area outside these guides will not work
causing an inconsistent heating pattern.
NOTE: If the Induction cooker has been turned on without a compatible pot in place the unit will beep for approximately 30 seconds,
error code E0 will be appear in the Display Window and the unit will shut off automatically.
NOTE: When the unit is off, the fan may continue running until the temperature of the Induction Cooker is below 50℃.
NOTE: NEVER heat empty cookware. This will cause the unit to overheat, damage the cookware and/or cause the unit to shut off.

CLEANING AND MAINTENANCE

Washing the appliance after each use is recommended. Disconnect the appliance from the mains socket and wait until it cools down.
Do not use petrol, solvents, brushes or pastes to clean the induction heating plate.
Wipe the appliance with a damp cloth with some dishwashing liquid. Use a vacuum cleaner to remove dirt from the air supply and fan
grilles. Clean the ceramic surface and the control panel with a soft damp cloth and gentle cleaners for ceramic surfaces.
Make sure that water does not drip on the cooker, as this can cause damage. Never immerse the appliance or the cable in water.
All servicing, other than cleaning, should be performed by an authorized service representative.
Error Codes:
E0: No pot.
------------------------------------------------------------------------------------------------------------------------------
E1: Low voltage
E2: Over voltage
E3: Thermistor module open
E4: Thermistor module short
E5: Thermistor to IGBT open
E6: Thermistor to IGBT short
E7: Thermistor module failure
E8: Inner failure
E9: Thermistor to IGBT overheat
EA: Bottom casing thermistor overheat or short or open
If the error code E0 is reported, please check if the cookware you are using is suitable for induction cooking or wait for the appliance to
7