User Information; Important Notes; Safety Instructions; Disposal - Bosch PC2018 Manual Original

2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and compa-
ny obligations, can be found in the separate manual "Im-
portant notes on and safety instructions for Bosch
". These instructions must be carefully studied prior to
start-up, connection and operation of the PC2018 and
must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety inst-
ructions for Bosch ". These instructions must be
carefully studied prior to start-up, connection and ope-
ration of the PC2018 and must always be heeded.
2.3

Disposal

This PC2018 is subject to European guideli-
nes 2012/19/EU (WEEE).
Old electrical and electronic devices, including-
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of PC2018.
Robert Bosch GmbH
3.

Product description

3.1

Intended use

The PC is intended for use in conjunction with products
from Robert Bosch GmbH . Any other or additional appli-
cation, e.g.in conjunction with non-approved products,
does not constitute the intended use. The operator of
the system is liable for any damage resulting from such
usage and not Robert Bosch GmbH.
i
As standard, the PC is already installed and connec-
ted in Robert Bosch GmbH products on delivery.
3.2

Operating environment

3.2.1

Ambient conditions

¶
The PC is to be protected against water and other
moisture, high temperatures and high humidity.
¶
Never operate the PC in the vicinity of products
which generate high temperatures or electromagne-
tic fields.
¶
Make sure the vent openings in the housing are not
obstructed.
¶
Position the PC on a stable, clean surface and do not
stand anything on the PC connecting cables.
3.2.2

Voltage supply

¶
Make sure the power supply corresponds to the
voltage indicated on the PC.
¶
Make sure the three-wire grounding-type connector
of the power supply unit is connected to a grounding
outlet.
¶
If the PC is connected by way of an extension cable,
make sure the total current level of all the devices
connected to this extension cable does not exceed
the permissible current level for the extension cable
and the fuse in the fuse box.
PC2018 | 11 en
|
1 690 706 143 2018-02-14