Electrical Safety; Machine Information; Technical Specifications - Ferm Industrial AGM1110P Traducción Del Manual Original

Electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.

2. MACHINE INFORMATION

Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard
must be used (not included)

Technical specifications

Model No AGM1110P AGM1112P AGM1114P
Mains voltage
Mains frequency
Power input
Rated speed
Wheel disc for grinding
Diameter 100 mm
Bore 16 mm
Spindle thread M10
Weight 1.98 kg
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration "Surface
grinding" a
h,AG
220-240 V~
50/60 Hz
710 W
N 11.000/min
0
115 mm 125 mm
22 mm 22 mm
M14 M14
2 kg 2.05 kg
86.4 + 3 dB(A)
97.4 + 3 dB(A)
6.334 + 1.5 m/s
2
Model No AGM1111P AGM1113P AGM1115P
Mains voltage
Mains frequency
Power input
Rated speed
Wheel disc for grinding
Diameter 100 mm
Bore 16 mm
Spindle thread M10
Weight 1.98 kg
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration "Surface
grinding" a
h,AG
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 60745; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
• using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Spindle lock button
2. On/Off switch
3. Protection guard
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
220-240 V~
50/60 Hz
850 W
N 11.000/min
0
115 mm 125 mm
22 mm 22 mm
M14 M14
2 kg 2.05 kg
86.4 + 3 dB(A)
97.4 + 3 dB(A)
6.334 + 1.5 m/s
2
7