Scott 350 EVO Manual Del Usuario página 6

CORRECT FITTING
Make sure that the helmet fits correctly as shown below, the helmet must NOT be too low
or high on the head because it will interfere with your line of sight. Eyes should be central to
the eye aperture. Please note that the visor found in our off-road helmets is adjustable. Try
the off-road helmet with the visor in all positions prior to purchase in order to satisfy your-
self that the helmet meets your requirements. SCOTT Sports SA shall not be liable for any
damages and losses due to incorrect fitting.
• IV. VISOR REMOVAL AND ADJUSTMENT
550 HELMET
Remove the two front screws from the visor. Press down on the
visor and give it a firm push toward the front. To replace the visor,
reverse the mentioned process.
Warning : Do not ride without visor.
Avoid damage to the visor by over tightening the screws. If in doubt
about maintenance or how to remove or replace parts of your hel-
met, please see your local dealer. DO NOT MAKE ANY CHANG-
550
ES OR MODIFICATIONS TO YOUR HELMET OTHER THAN THOSE
SPECIFIED BY THE MANUFACTURER, AS THIS COULD SERIOUS-
LY REDUCE THE PERFORMANCE AND SAFETY OF YOUR HEL-
MET. SCOTT Sports SA shall not be liable for any damages and loss-
es due to any improper changes or modifications.
350 EVO, 350 EVO KID HELMETS
Remove the two side screws and washers from the visor. Remove
the central screw located underneath the visor. To replace the visor,
reverse the mentioned process.
350 EVO
Avoid damage to the visor by over tightening the screws. Use the
central screw to lock the visor in your favored position. If in doubt
about maintenance or how to remove or replace parts of your hel-
met, please see your local dealer. DO NOT MAKE ANY CHANGES
OR MODIFICATIONS TO YOUR HELMET OTHER THAN THOSE
SPECIFIED BY THE MANUFACTURER, AS THIS COULD SERIOUS-
LY REDUCE THE PERFORMANCE AND SAFETY OF YOUR HEL-
MET. SCOTT Sports SA shall not be liable for any damages and loss-
es due to any improper changes or modifications.
350 EVO KID
ENGLISH - 6