Airflow Direction Control; Important - Telstar TAI012112MD Manual De Instrucciones

AIRFLOW DIRECTION CONTROL

Range
Deflector rod
Range
CAUTION
Do not operate the air conditioner for long periods with the air flow direction set
downward in cooling or dehumidifying mode. Otherwise, condensation may occur
on the surface of the horizontal louver causing moisture to drop on to the floor or on
furnishings.
When the air conditioner is started immediately after it was stopped, the horizontal
louver might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as COOLING or
HEATING performance may be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise the horizontal louver will be
out of sync. Please cease operating, unplug power for a few seconds, then restart
the air conditioner.
Do not operate unit when the horizontal louver is in closed position.
Adjust the air flow direction properly, otherwise
it might cause discomfort or cause uneven
room temperatures.
Adjust the horizontal louver using the remote
controller.
Adjust the vertical louver manually.
To set the vertical air flow (Up--Down)
direction
Perform this function while the unit is in opera-
tion. Use the remote controller to adjust the air
flow direction. The horizontal louver can be
moved at
a range of 6O for each press, or swing up and
down
automatically. Please refer to the REM,O,TE
CONTROLLER OPERATION MANUAL for details.
To set the horizontal air flow direction (left -
right)
Move the deflector rod manually to adjust the
air flow in the direction you prefer.
IMPORTANT: Do not put your fingers into the
panel of blower and suction side The
high-speed fan inside may cause danger.