Airflow Direction Control - Telstar TAS012112MD Manual De Instrucciones

AIRFLOW DIRECTION CONTROL

Range
Deflector rod
Range
CAUTION
Do not operate the air conditioner for long periods with the air flow direction set downward in
cooling or dehumidifying mode. Otherwise, condensation may occur on the surface of the
horizontal louver causing moisture to drop on to the floor or on furnishings.
When the air conditioner is started immediately after it was stopped, the horizontal louver
might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as COOLING or HEATING
performance may be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise the horizontal louver will be out of
sync. Please cease operating, unplug power for a few seconds, then restart the air condition-
er.
Do not operate unit when the horizontal louver is in closed position.
Adjust the air flow direction properly, otherwise it
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal louver using the remote
controller.
Adjust the vertical louver manually.
To set the vertical air flow (Up--Down) direction
Perform this function while the unit is in operation.
Use the remote controller to adjust the air flow
direction. The horizontal louver can be moved at
a range of 6O for each press, or swing up and
down
automatically. Please refer to the REM,O,TE
CONTROLLER OPERATION MANUAL for details.
To set the horizontal air flow direction (left - right)
Move the deflector rod manually to adjust the air
flow in the direction you prefer.
IMPORTANT: Do not put your fingers into the panel
of blower and suction side The high-speed fan
inside may cause danger.
A/C
TAS012112MD