Buttons; Socket - EDAN INSTRUMENTS SONOTRAX Serie Manual Del Usuario

SONOTRAX Series Ultrasonic Pocket Doppler User Manual
FHR Displaying:
Here displays the fetal heart rate value, whose unit is bpm (beat per minute).
Probe Type:
The Doppler can detect and identify the probe: when the probe is not connected or not well
connected to the Doppler, the "---" symbol and "MHz" symbol on the LCD screen flash;
when the probe is well connected, the flashing stops, the probe type displays on the LCD
screen.
Communication
The Doppler can communicate with PC. This function is reserved.

3.3 Buttons

At most there are four push buttons (Power, MODE, START/STOP and REC/PLAY) and a
volume control button on the SONOTRAX Series Ultrasonic Pocket Doppler. Their primary
functions are as follows:
(1) Power Button
Function: Switch on or off the Doppler.
(2) MODE Button
(Only for SONOTRAX Basic / SONOTRAX Basic A/ SONOTRAX Pro/ SONOTRAX II/
SONOTRAX II Pro)
Function: Select the working mode.
(3) START/STOP Button
(Only for SONOTRAX Basic/ SONOTRAX Basic A/ SONOTRAX Pro/ SONOTRAX II/
SONOTRAX II Pro)
Function: Start/ stop monitoring (Mode 3)/ setting (Mode 4 and Mode 5).
(4) REC/PLAY
(Only for SONOTRAX Pro/ SONOTRAX II Pro)
Function: Start/ stop recording or playing.
(5) Volume Control Indicator
Function: Adjust volume. Rotate the volume gear clockwise to turn up the volume, while
rotate it anti-clockwise to turn down the volume.
- 8 -
SONOTRAX Series Ultrasonic Pocket Doppler User Manual

3.4 Socket

The two sockets are located on the top panel of the Doppler.
(1) Earphone socket : the earphone or line-in cable connects to the Doppler via this
socket.
Figure 3-6 Line-in Cable
: Attention. Refer to the accompanying documents.
Signal Interface
1 GND 2 Signal
1
3 Signal 4 Signal
4
2
3
5 Signal
5
(2) Charge socket : the special lithium-ion polymer battery charger connects to the
Doppler via this socket.
Pro only)
NOTE: Accessory equipment connected to the analog and digital interfaces
must be certified according to the respective IEC standards (e.g. IEC
950 for data processing equipment and IEC 60601-1 for medical
equipment). Furthermore all configurations shall comply with the valid
version of the system standard IEC 60601-1-1. Everybody who connects
additional equipment to the signal input connector or signal output
connector configures a medical system, and is therefore responsible
that the system complies with the requirements of the valid version of
the system standard IEC 60601-1-1. If in doubt, consult our technical
service department or your local distributor.
(For SONOTRAX II and SONOTRAX II
- 9 -