Hilti AG 125-A36 Manual Del Usuario página 32

Ocultar thumbs Ver también para AG 125-A36:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
Note
The optional Kwik lock nut can be used instead of the standard clamping nut. Accessory tools (discs
etc.) can then be changed without need for additional tools (keyless system).
1. Remove the battery. → page 24
2. Clean the clamping flange and the quick-release clamping nut.
3. Fit the clamping flange onto the drive spindle.
4. Fit the accessory tool.
5. Screw on the Kwik lock nut until it is seated against the accessory tool.
◁ The name Kwik lock should be visible when the nut is screwed on.
6. Press the spindle lockbutton and hold it in this position.
7. Turn the accessory tool firmly by hand in a clockwise direction until the Kwik lock nut is tightened
securely and then release the spindle lockbutton.
5.7.4 Removing an accessory tool secured with a Kwik lock nut
1. Remove the battery. → page 24
CAUTION
Risk of breakage and irreparable damage. If the spindle lockbutton is pressed while the spindle is
rotating, this may cause the accessory tool to work loose or detach from the power tool.
▶ Press the spindle lockbutton only when the spindle has stopped rotating.
2. Press the spindle lockbutton and hold it in this position.
3. Release the Kwik lock nut by turning it counterclockwise by hand.
4. If the Kwik lock nut cannot be released by turning it by hand, use a pin wrench to turn the nut in a
counterclockwise direction.
Note
Never use a pipe wrench! A pipe wrench could damage the Kwik lock nut.
5. Release the spindle lockbutton and remove the accessory tool.
6 Operation
6.1 Grinding
CAUTION
Risk of injury. The accessory tool may suddenly stick or stall.
▶ Use the power tool with the side handle (or optional hoop grip) fitted and always hold the power
tool securely with both hands.
6.2 Cutting
▶ When cutting, apply moderate feed pressure and do not tilt the power tool or the cutting disc (when
working, hold at approx. 90° to the surface being cut).
Note
For best results when cutting profiles and square tube, start cutting at the smallest cross section.
6.3 Rough grinding
CAUTION
Risk of injury. The abrasive cutting disc could shatter and flying fragments may cause injury.
▶ Never use abrasive cutting discs for grinding.
▶ Move the power tool to and fro while maintaining a 5° to 30° angle of attack and applying moderate
pressure.
◁ This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
26
English
Printed: 15.12.2016 | Doc-Nr: PUB / 5246577 / 000 / 02

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ag 150-a36

Tabla de contenido