Jabra Pro 9450 Guia De Inicio Rapido página 11

STEP 6: CONFIGURE THE SOUND
Desk phone sound
1 Ensure the headset is docked, and then press and hold the desk phone
button on the base keypad until the desk phone icon changes to
2 Remove the front panel of the Jabra Pro 9450, as illustrated.
3 Put on the headset. The desk phone icon will change to
not change, tap the desk phone button on the base keypad.
4 Press the headset button on the desk phone, or lift the desk phone handset,
to get a dial tone.
5 Make a test call. Dial a friend or colleagues phone number using the desk
phone.
6 Check your speaking volume. If the listener says your speaking volume is
too quiet or too loud, adjust the microphone volume control on the base, as
illustrated. Ensure the listener does not adjust their own volume.
7 When finished, end the call and return the front panel of the Jabra Pro 9450
IMPORTANT
Having sound Problems?
If you cannot hear anything, or the sound is distorted, during
the desk phone call, try rotating the clear dial tone switch from
A-G until the sound is optimal. For further details see section
3.1 Configuring for Desk Phones, in the user manual.
PC (softphone) sound
1 Download and install Jabra PC Suite from jabra.com/support.
2 Open your PC phone software (softphone) and set the Jabra Pro 9450 as speaker and microphone in
the softphone's audio configuration settings.
3 Ensure the headset is docked, and then press and hold the softphone button on the base keypad until
the softphone icon changes to
4 Make a test call. Put on the headset, and dial a friend or colleague´s phone number using the
softphone software. The softphone icon will change to
5 When finished, end the call.
YOU HAVE NOW SUCCESSFULLY CONNECTED YOUR JABRA PRO 9450
.
8
.
. If the icon does
.