HMM Diagnostics smartLAB Manual De Usuario página 35

Setting signal tone:
After you entered your step length, you can set the device signal tone ( ). By
pushing the "M/" button, you can choose if the signal beep is activated ("ON") or
not("OFF").Pleaseconfirmagainwiththe„Disp/Set"button.
Setting time:
After that, your device enters the time setting mode. Press the "M/" button in order
to switch between the two display modes 12h and 24h (24h mode is preset).
By pushing „Disp/ Set" button you can set the time. First you set the hours by
pushing the "M/"button.Confirmbypushing„Disp/Set".Afterwards,youcanset
theminutesbyrepeatingthestepsmentioned.Finallyconfirmagainwiththe„Disp/
Set" button.
Note: Setting your weight and step length is essential for the display of walked
distances and burned calories. You need to enter correct values for both parameters.
Otherwise it is impossible for smartLAB
® walk B to display correctly your walked
distance and calory consumption.
35