Open And Close Unit; Power The Unit/Print Positioning - Uline H-2812 Manual De Instrucciones

OPEN AND CLOSE UNIT

OPEN UNIT
1. Insert the key into the lock on cover of the unit. Turn
the key in the clockwise position to unlock the unit.
Remove the cover. (See Figure 1)
Figure 1
When you open the unit for the first time,
you must remove the Protective Pad and
Cardboard Insert. Plug the AC Adapter
into the back of the unit. Refer to Remove
Protective Pad and Cardboard Insert/Plug
AC Adapter into Unit below. (See Figure 2)
Ribbon may dislodge. To avoid damage to the
printer, press the ribbon cartridge firmly into
position after removing the protective pad.
(See Figure 2)
2. Remove protective pad and cardboard insert. Plug
AC adapter into unit. (See Figure 2)
Figure 2
Cardboard
Insert
PAGE 5 OF 57
SETUP CONTINUED
AC Adapter
Protective
Pad
CLOSE UNIT
Replace the cover. Insert the key into the lock on the
cover of the unit. Turn the key in the counter-clockwise
position to lock the unit. (See Figure 3)
Figure 3

POWER THE UNIT/PRINT POSITIONING

Plug the transformer into the AC outlet.
Insert a card to get a sample print.
(See Figure 4)
Figure 4
Print position from the card edge is adjustable by pressing
and sliding the print position button located on the right
outside bottom of the unit. Maximum distance from
edge of form to print is approximately 1⁄" (30 mm).
(See Figure 5)
Figure 5
Print Position on Time Card
AC Outlet
AC Adapter
0721 IH-2812