Important Things To Remember When Using The Es700; Program The Time Recorder - Uline H-2812 Manual De Instrucciones

IMPORTANT THINGS TO REMEMBER
WHEN USING THE ES700
You must open the unit to make changes
to the settings. After each use, replace the
cover and lock it. Refer to "Open and Close
Unit" on page 5.
After performing each procedure on the unit, remember
to press SET until the unit returns to normal operation
mode. To exit program mode anytime, press SET until the
unit returns to normal operation mode. (See Figure 6)
Figure 6
When you are setting a digit or an option on
the display, flashing means that it is ready to
be changed. You must press SELECT until you
reach the desired digit or option. Then press
SET to lock the desired value in place.
Printing is always disabled while settings are being
changed. Once the final SET has been completed in
any given operation, printing is enabled.
PAGE 6 OF 57
SETUP CONTINUED

PROGRAM THE TIME RECORDER

Press SELECT. The unit changes into the program mode
showing
mark. (See Figure 7)
Figure 7
(+/&6%,"&%i!GPMi%*-6CA%
TIME RECORDER FUNCTION BUTTONS
CONTROL
SELECT
CHANGE
SET
Most of the procedures in this manual are
performed from the Time Recorder menu.
Refer to Time Recorder Menu below and to
Time Recorder Function Buttons below.
on the display positioned under the "TIME"
p
Time Recorder Menu
-:F1(&1=28A18()15>
SELECT
Press
gram setting mode. The selected program
mode is indicated by p on the display.
CHANGE
Press
tions.
SET
Press to set the option. After an option
has been set, always press
return the unit to normal operation mode.
FUNCTION
to choose the desired pro-
to cycle through the op-
SET
again to
0721 IH-2812