Replacement Parts List - Stiga ESCALADE SPORTS T8712 Manual Del Usuario

BOTTOM SIDE OF HALF TOPS #1 SHOWN
INSTALLATION Contd.
1. Determine the placement of sponge rubber strips #5 on the bottom of
half tops as follows (Use Figure 3):
l Measure the width of your pool table.
l Divide the width of your pool table in half and mark the bottom of the
conversion top this amount (B). Measure from center line (A) out toward
both sides. These mark the sides of your pool table.
l Measure the length of your pool table.
l Divide length of pool table in half and mark the bottom of the conversion
top this amount (D). Measure from center line (C) (where two half tops
touch) out towards both ends. These mark the ends of your pool table.
Temporarily tape sponge rubber strips #5 to bottom surface of
l
conversion top using masking tape (not included). Space them evenly
apart as shown above. (Do not peel backing off strips yet. First check
for correct placement. See next step.)
2. Set one half top on your pool table to check for correct placement of
sponge rubber strips #5.
l If correctly placed, remove top from pool table, peel backing from
sponge rubber strips #5 and apply firmly to back of conversion top.
Repeat on other half top. Place both half tops on pool table.
l
If incorrectly placed, mark the correct position on bottom of the
conversion top, remove top from pool table, and apply strips.
Repeat on other half. Set both half tops on pool table.
3. Install net brackets and net (not furnished with this table).
Figure 3
TOP SIDE OF HALF TOPS #1 SHOWN
WITH POOL TABLE UNDERNEATH.
Figure 4

Replacement Parts List

ITEM # PART #
1 4A-5497-00
2 4A-5498-00
3 1A-4114-00
4 2S-4551-01
5 2M-4148-00
6 1B-4142-00
7 2L-5050-00
#2
3
DESCRIPTION
4 PC. TOP SECTION - R.H.
4 PC. TOP SECTION - L.H.
HINGE
STIFFENER CHANNEL
SPONGE RUBBER STRIP
#6 x 7/16 FLAT HD. SMS
THIS OWNER'S MANUAL
#3
#6
#4
QTY
2
2
6
2
12
24
1
#5
#1
2L-5050-00