GE 45255 Guia De Inicio Rapido

If you have any problems or questions,
contact our expert TECH SUPPORT TEAM at
1-800-654-8483, option 1
Monday–Friday, 8–5pm CST
For the most up-to-date product support, accessories,
electronic (PDF) format manuals and more, visit
www.jascoproducts.com/support
is a trademark of General Electric Company and is under license by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114
45255-QS ver1
DO NOT
RETURN THIS
PRODUCT TO
THE STORE!
QUICKSTART GUIDE
 PACKAGE CONTENTS
(1) Monitor
(1) Charging cradle
(1) Camera
(2) AC power supply adapters
(1) Mini USB cable
(1) CD (PC Monitoring Software)
(1) Camera wall plate and mounting hardware
FOR YOUR CONVENIENCE
The camera is already paired to channel 1 of the monitor
at the factory. No additional programming is needed!
 CAMERA OPERATION
For Battery Power:
For AC Adapter Power:
Push the tab to release the cover,
Plug AC power adapter into the base
and insert 4 AA batteries, following
of the camera, and into an electrical
the polarity diagram shown inside
outlet.
the compartment.
TABLETOP
Slide the power switch to 'ON—the Position the camera at the best angle
power LED will glow green below the for viewing—tabletop or wall mount—
and in a dry, protected location
OFF position. A fl ashing POWER LED
(indoors.)
indicates batteries are low.
For more detailed information on the features and operation of this product,
please refer to the user's manual included in the package.
power
switch
monitor
AC power
power
LED
AC power
battery
compartment
(4 -AA)
RED=Charging GREEN=Full charge
 MONITOR OPERATION
AC Adapter into Monitor: AC Adapter into Cradle:
Plug AC power adapter into the Plug AC power adapter into the
right side of the monitor, and into rear of the charging cradle, and
an electrical outlet. Slide the power place monitor into the cradle. Slide
switch on the left side of the monitor the power switch on the left side
to the 'on' position. The charging of the monitor to the 'on' position.
LED will glow near the power input. The charging LED will glow near the
power input.
NOTE: Depending on the current state of the battery, it can take
up to 6 hours to fully charge the monitor. A fl ashing POWER LED
indicates a low battery.
The monitor will automatically scan for the camera and
WALL then the video will appear on the screen. The built-in
MOUNT speaker will automatically broadcast live audio from the
camera. Volume is adjusted using the buttons located on
top of the monitor.
It's that simple!
Charging
Light
power
switch