Tivoli Audio The Connector El Manual Del Propietario página 9

Guide to Features (Rear panel):
Note: Audio and video connections should always be made while The Connector is turned off.
2
1
1. 5VDC 1A: Connect the included external power supply's cable into this input. Should the
power supply ever be damaged or misplaced, use only a like replacement. The power supply's
connector is 5.5mm/2.1mm center positive. Using a different power supply could result in
damage to The Connector or your iPod.
2. S-VIDEO: Connect an S-Video cable (not included) to this output, and the other end of the cable
to a television's S-Video input to watch videos stored on your iPod. This output will provide a
superior picture to the composite video output. Be sure your iPod video settings are enabled
in order to get a video signal.
3. VIDEO OUT: Connect a composite video cable (not included) to this output, and the other
end of the cable to a television's composite input to watch videos stored on your iPod. Be
sure your iPod video settings are enabled in order to get a video signal.
4. AUDIO OUT: Connect one end of the included audio cable to this output, and the other end to
the Auxiliary input of your Tivoli Audio radio (or other audio device). This output is not designed
for use with headphones.
Note: Be sure your iPod video settings are enabled (if your iPod model supports video out) in
order to get a video signal.
All manuals and user guides at all-guides.com
English
3
4
9