Connec Ng Equipment To The Twr-5 - Gallagher TWR-5 Guia De Inicio Rapido

CONNECTING EQUIPMENT TO THE TWR-5
Connecting an EID Reader
• The TWR-5 internal reader can be used with or without loadbars connected.
To use the internal reader, you must fi rst connect the antenna panel. Refer to
A aching the TWR-5 to the Antenna panel (p. 6).
• A Hand-held EID Reader or permanent reader can be connected to the TWR-
by either a serial cable or via Bluetooth®.
1. If using a hand-held reader or permanent reader, turn On the EID Reader.
2. For all readers, turn On the TWR- .
3. On the TWR- , tap
4. Select how the Reader is being connected. This will be by Bluetooth, Serial
cable, USB or using the internal reader (Panel).
If using the internal reader, a successful connec on will show as
footer bar.
Note: A mini serial adapter is included with the TWR- if a female serial
connec on is required.
Important: The TWR- can also be connected to via Bluetooth as a "Slave",
by ini a ng the connec on from the reader. A pass-code of "0000" may be
required to complete this connec on.
Refer to Bluetooth – Connect EID Reader in the TWR-5 On-screen Help or your EID
Reader User Manual for further informa on on pairing the reader.
Connecting to a Drafter/Sorter
To connect the TWR- to a dra er, use the data cables supplied with your dra er.
Refer to your Dra er User Manual for more informa on.
1. Turn On the TWR- .
2. On the TWR- , tap
3. Specify the type of dra er that is being connected, to complete the setup.
If your dra er is not listed, tap
wizard set up your dra er.
8
Gallagher TWR- Weigh Scale Quick Start Guide
Se ngs > Equipment Connec ons > EID Reader
Se ngs > Equipment Connec ons > Dra er
Create Custom
and follow the confi gura on
.
in the
.