Satellite 4R Guia De Inicio Rapido página 5

Thank you for choosing this JBDC product; please read this instruction manual carefully before installing and using
the product, and keep in a safe place for future reference.
3-phase MIG/MAG generator POWERMIG TWIN
POWERMIG GENERATOR 400W. Both accept 200 and 300 mm wire reels.
The SATELLITE 4R is equipped with
PRESENTATION (I, page 2)
① Reel support (200 or 300mm)
② Wire feeder
③ Handle
④ Wire speed potentiometer
⑤ Euro torch connector
⑥ Lateral torch holder
ASSEMBLY & CONNECTION (II, page 2)
Installing the swivel support on the PowerMig Twin 400-4/ PowerMig Generator 400W
Use the 3 screws supplied to fix the bottom part of the swivel support onto the generator
The upper part of the support is already fixed under the wire feeder.
Gas Coupling
SATELLITE 4R: Fit the gas pipe to the connectors ⑫ and ⑬ (for the generator) located at the back of the
PowerMig Twin 400-4 (pipes and collars not included).
SATELLITE 4W: Fit the gas pipe to the connector ⑫ located at the back of the PowerMig Twin 400-4
(pipes and collars not included).
Contact Cable Connection
Connect the wire feeder to the generator, making sure that the power and water connectors are securely
tightened (⑪ and ⑭).
WIRE REEL INSTALLATION (III, page 2)
Open the door of the machine.
Position the reel on to the support ①.
Adjust the break ②, to avoid reel movement tangling the wire when the welding stops.
Tighten the plastic screw firmly ③.
For the first use :
o Release the fixing screw of the wire guide ④
o Put the rollers in place ⑤. The visible diameter on the roller should be equal to the wire diameter used.
o Place the wire guide ⑥ as close as possible to the roller but without touching it, then tighten the fixing screw.
To select the adjustment of the drive rollers: loosen the drive roller knob as far as possible ⑦, insert the wire until
it exits the other side by about 2cm. Start the motor by pressing the torch trigger, tighten the knob whilst pressing
the trigger. Bend the wire where it comes out of the nozzle and hold it in place to stop its progress - the setting is
correct when the guide roller slides over the wire, even when it is blocked at the end of the torch.
USE
SATELLITE 4R/ SATELLITE 4W allows the user to weld using the parameters set on the MIG generator. To
adjust the settings to the type and diameter of wire used, please refer to POWERMIG TWIN 400-4's or
POWERMIG GENERATOR 400W's manual.
It is possible to change the wire speed, in synergic or manual mode using the potentiometer on the front panel.
In order to use the separate wire feeder's torch, press the trigger - the LEDs on the generator's control panel
will start to flash, indicating the change of torch.
400-4. SATELLITE 4W is an air-cooled separate wire feeder for the
a swivel support to be fixed on the POWERMIG TWIN 400-4.
⑦ Wheels
⑧ Upper section of the swivel support
Rear panel for contact cable connection
⑨ Gas connector
⑩ Control cable connector
⑪ Power cable connector
SATELLITE 4R is an air-cooled separate wire feeder for the
5