Metra BX-GM2 Instrucciones De Instalación página 2

From the 16-pin harness to the aftermarket radio:
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Plug the 16-pin harness into the vehicles wiring harness.
From the 12-pin harness to the aftermarket radio:
• The 12-pin harness is to be used in conjunction with the optional ASWC-1 (not
included) to retain steering wheel controls. If the ASWC-1 is not being used,
disregard this harness. If it will be used, please refer to the ASWC-1 instructions
for programming.
• Tip: If your vehicle is amplified, for best sound quality solder RCA ends onto the
BX-GM2 speaker wires and use your radios RCA pre-outs instead.
INSTALLING THE BX-GM2
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, and on again.
METRA. The World's best kits.
BX-GM2
1-800-221-0932
™
Caution: Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be plugged in
before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
IMPORTANT WARNING
This product includes instructions for installation which must be carefully followed. The instructions
are worded in such a manner to assume that the installer is capable of completing these type of
electronic installations. If you are unclear as to what you are instructed to do or believe that you do
not understand the instructions so as to properly and safely complete the installation you should
consult a technician who does have this knowledge and understanding.
Failure to follow these instructions carefully and to install the interface as described could
cause harm to the vehicle or to safety systems on the vehicle. Interference with certain
safety systems could cause harm to persons as well. If you have any questions in this
regard please call the Help line or Metra at 1-800-221-0932 for assistance.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
metraonline.com
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians