MILLET SUMMIT Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
english
INSTRUCTIONS
IMPORTANT!
For your protection, please read this leaflet and follow the instructions.
This climbing and mountaineering helmet has been designed for additional safety when taking
part in the following sports: climbing and mountaineering, excluding any other sports, whether
motorised or not.
Wearing a helmet reduces the risk of head injury.
WARNING
Fasten the helmet securely before beginning the activity and keep it on for the whole duration of
said activity. Take off any head accessories that are rigid or might get in the way before putting
on your helmet (hairslides, etc.). Ensure your helmet has been properly adjusted to fit you before
each use. Any protective item has limits, but wearing this helmet may help in reducing the
seriousness of any head trauma you might suffer in an accident. This helmet does not protect the
uncovered areas of your head such as the face and nape of the neck. Always engage in your sports
activity with due care and while complying with the responsibility and health and safety practices
relating to it.
USE
STORAGE: keep your helmet away from all heat sources. Never exceed 40°C. Prolonged exposure
to sunlight weakens the characteristics of the materials used.These conditions are often exceeded
inside cars parked in the sun.
SETUP
• Depending on your size, choose and apply the most suitable comfort pads: fig .1
• Thin pads = Size M / 55 - 59 cm
• Thick pads = Size L / 57 - 61 cm
• Position the helmet on your head, making sure it isn't too far forward or too far back. fig .2
• Adjust the fit of the helmet with the dial on the back. fig. 3
• Close the chinstrap buckle; you should hear it click. fig .4
• Adjust the chinstrap to ensure the helmet stays on securely. The helmet should be tight but
not excessively tight to the point it restricts your breathing. The helmet needs to stay firmly in
place when you're moving.
MAINTENANCE
Only use clean water and soap to clean the helmet. Do not use benzene, solvent or any other
chemical substances. Do not make any modifications to the helmet. Do not varnish it or add any
products to colour it. Do not cut off the ends of the straps. Do not put any stickers on it.
2

Publicidad

Tabla de contenido
loading

Productos relacionados para MILLET SUMMIT

Este manual también es adecuado para:

Pro

Tabla de contenido