12. Install the Handle
Find the vertical middle point of the inside panel. Mark the middle point on the side of the panel
nearest to the showerhead.
Cut a 2-3/8" (6 cm) piece of pressure sensitive tape. Remove the protective backing from one side of
the tape and apply the adhesive side to the handle.
Remove the paper backing from the second side of the pressure sensitive tape. Keeping the curved
side of the handle toward the inside of the shower, align the handle with the mark on the panel.
Firmly push the handle onto the side of the back panel. If necessary, lightly tap the handle into
place with a hammer, taking care not to mar the surface.
1034040-2-B
Inside
Panel
Inside of
Bath
Pressure
Sensitive
Tape
Handle
12
Sterling